>
Hyundai Equus: Power Mosfet Repair procedures
| Inspection |
| 1. |
Turn the ignition switch ON. |
| 2. |
Manually operate the control switch and measure the voltage of the blower motor. |
| 3. |
Select the control switch to raise the voltage until high speed.
Specification
|
| 4. |
If the measured voltage is not within specification, substitute with a known-good power mosfet and check for proper operation. |
| 5. |
Replace the power mosfet if it is proved that there is a problem with it. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim") |
| 3. |
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down.
|
| 4. |
Disconnect the under lamp connector (A).
|
| 5. |
Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after loosening the mounting screws.
|
| 6. |
Install in the reverse order of removal. |
Blower Motor Repair procedures
Climate Control Air Filter Description and OperationClimate control system
1. Driver’s temperature control knob
2. Front windshield defrost button
3. Rear window defrost button
4. AUTO (automatic control) button
5. Fan speed control button
6. OFF button
7. Air inta ...
Repair procedures
Inspection
Relex Power Seat Module (RPSM) For Passenger & Rear
Glossary
-
RPSM : Relax Power Seat Module
-
Combined RELAX SW : Combined RELAX SWITCH
-
Combined WALK IN SW : Combin ...
Cleaning the lap/shoulder belt webbing
Clean the belt webbing with any mild soap solution recommended for cleaning upholstery
or carpet. Follow the instructions provided with the soap. Do not bleach or re-dye
the webbing because this m ...