>
Inspection |
1. |
The DDM inputs can be checked using the GDS. |
2. |
To check the input value of door lock switch, select option "IPM". |
3. |
Select option "DDM (Driver Door Module)". |
4. |
Select option "Input/Output monitoring". |
5. |
To check the input value of door lock switch in force mode, select option "ACTUATION TEST". |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim. (Refer to the Body group - "Front Door") |
3. |
Disconnect the DDM module connector (A). |
4. |
Remove the DDM module with power mirror switch after loosening the mounting screws. |
Installation |
1. |
Install the DDM module. |
2. |
Install the front door trim. |
ECU Schematic Diagrams
Circuit diagram
1.
ECU Connector
2.
ECU Terminal function
TerminalFunction1Ground2Ground3IGN4Battery5Battery6-7-8-9-10-11-12Reverse Valve 1x(M1 Low Side)13Ambiance Valve14Reverse Valve 2x( ...
Photo Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will ri ...
Telemetics Unit (TMU) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front AVN monitor.
(Refer to "Premium AVN System")
3.
Remove the MTS unit after loosening the screw and nuts.
4.
...