>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk") |
3. |
Remove the power latch (A) after removing the bolts (2EA) and connector (B). |
Installation |
1. |
Install the power latch and connector. |
2. |
Install the trunk trim. |
3. |
Connect the negative (-) battery terminal and check the power trunk module correctly. |
Inspection |
1. |
Check the power trunk module input/output value by using the
GDS. If the operation of power trunk module is abnormal, replace power
trunk drive unit. |
2. |
To check the DTC of the power trunk module, select "PTM" |
3. |
Select "Input/output monitoring". |
Front Door Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Description and Operation
Memory Power Seat (PSM) Control (For Driver)
Description
The seat operation function in PSM contains the following functions.
1.
Manual control(CAN Signal data from DDM to PDM) with manual switc ...
Front fog light
Fog lights are used to provide improved visibility and avoid accidents when visibility
is poor due to fog, rain or snow etc. The fog lights will turn on when fog light
switch (1) is turned to ...