>
Inspection |
1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
2. |
Remove the front door module.
(Refer to Body - "Front Door Module") |
3. |
Disconnect the connectors from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
5. |
Disconnect the power ajar switch connector from door lock actuator. |
6. |
Check for continuity between terminals in half latching condition according to the table. |
7. |
Operate the cinching reset procedure when power door latch operation (automatic full latching) is faulty.
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim") |
2. |
Remove the rear door module.
(Refer to Body - "Rear Door Module") |
3. |
Disconnect the connectors from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
5. |
Disconnect the power ajar switch connector from door lock actuator. |
6. |
Check for continuity between terminals in half latching condition according to the table. |
7. |
Operate the cinching reset procedure when power door latch operation (automatic full latching) is faulty.
|
1. |
Remove the trunk trim.
(Refer to Body - "Trunk Trim") |
2. |
Disconnect the 4P connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Disconnect the connector (A) and bolts from the hood switch. |
2. |
Check for continuity between the terminals and ground according to the table.
(Refer to Body - "Hood Latch") |
Troubleshooting
Troubleshooting
SymptomSuspect areaEngine will not start or stuggle to startVapor hose damaged or disconnectedEngine stuggle to startMalfunction of the Purge Control Solenoid ValveRough idle or e ...
Before starting
Close and lock all doors.
Position the seat so that all controls are easily reached.
Adjust the inside and outside rearview mirrors.
Be sure that all lights work.
Check all gauges.
Check ...
To control the vehicle height
Push the vehicle height control button to select the HIGH mode that makes the
vehicle higher than the NORMAL mode and the indicator light on the vehicle height
control button will illuminate. It i ...