>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Disconnect the connector from the front bumper cover.
(Refer to Body - "Front Bumper Cover") |
3. |
Pull out the sensor (A) by opening the sensor holder out. |
4. |
Disconnect the connector from the sensor. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Disconnect the connector from the rear bumper cover.
(Refer to Body - "Rear Bumper Cover") |
3. |
Pull out the sensor (A) by opening the sensor holder out. |
4. |
Disconnect the connector from the sensor. |
Installation |
1. |
Install the senosr after connecting the connector. |
2. |
Connect the negative (-) battery terminal. |
1. |
Install the senosr after connecting the connector. |
2. |
Connect the negative (-) battery terminal. |
Filter inspection
The climate control air filter should be replaced every 15,000 miles (24,000
km). If the vehicle is operated in severely air-polluted cities or on dusty rough
roads for a long period, it should be ...
Power Trunk (if equipped)
(1) Power Trunk Main Control button
(2) Power Trunk Open button
(3) Power Trunk Close button
(4) Power Trunk Lock button
To open:
1. Make sure the shift lever is in P(Park).
2. Then do one o ...
Cylinder Block Components and Components Location
Components
1. Cylinder block bank cover2. Cylinder block bank cover gasket3. Cylinder block rear cover4. Cylinder block rear cover gasket5. Separator6. Drain plug7. O-ring8. Piston oil jet9. Chec ...