Hyundai Equus: Output Speed Sensor Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Output Speed Sensor Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Output Speed Sensor Description and Operation
| Description |
The output speed sensor is a vital unit that measures the
rate of rotation of the transmission's turbine shaft and output shaft,
and delivers the readings to the TCM. The sensor provides critical input
data that's used in feedback control, damper clutch control, gear
setting control, line pressure control, clutch activation pressure
control, and sensor fault analysis.
Transmission Oil Temperature Sensor Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Output Speed Sensor Specifications
Specifications
x Type: Hall effect sensor
x Specifications
Operation condition (°C)°F((-)40~150)) -40~302Air gap(mm)in.1.3(0.0512)Output voltageHigh1.4Low0.7
...
See also:
Front Door Window Glass Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the door outside belt weatherstrip.
3.
Remove the plug hole (A).
• ...
Air Lumber Support Switch Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the shield outer cover.
(Refer to Body - "Front Seat Shield Outer Cover")
3.
Disconnect the power seat air lumber supp ...
Front Washer Motor Repair procedures
Removal
1)
When servicing the washer pump, be careful not to damage the washer pump seal.
2)
Do not operate the washer pump before filling the washer reservoir.
Failure ...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com