>
The indicator on the switch will illuminate when the BSD (Blind spot detection) system switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds 9.3 mph (15 km/h), the system will activate. If you press the switch again, the switch indicator and system will be turned off.
If the ignition switch is turned OFF and ON the system returns to the previous state.
When the system is not used, turn the system off by turning off the switch.
When the system is turned on, the warning light will illuminate for 3 seconds on the outside rearview mirror.
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
2 ...
License plate lamp replacement
1.Open the trunk.
2.Disconnect the negative battery cable.
3.Using a screwdriver, remove the trunk lid latch cover(1).
4.Using a screwdriver, remove the trunk lid switch(2), and disconnect ...
Yaw-rate and Lateral G Sensor Description and Operation
Description
The ESP system is the shorten word of Electronic Stability
Control system. This system recognizes a critical driving condition by
Yaw-rate sensor, Lateral acceleration sensor and St ...