>

Hyundai Equus: Oil Pressure Switch Repair procedures - Lubrication System - Engine Mechanical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Oil Pressure Switch Repair procedures

Inspection
1.
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.

2.
Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.

3.
If there is no continuity when a 49.0kPa (0.5kg/cmx, 7.1psi) is applied through the oil hole, the switch is operating properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.
    Oil Pump Repair procedures
    Removal 1. Remove the sub frame. (Refer to SS group) 2. Drain engine oil. (1) Remove the oil filler cap. (2) After lifting the car, remove the oil drain plug and drain oil into a conta ...

    Intake And Exhaust System
    ...

    See also:

    Repair procedures
    Refrigerant System Service Basics Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the ...

    Height Sensor Schematic Diagrams
    Circuit diagram 1. Height sensor connector 2. Height sensor terminal function TerminalFunction1Height Sensor Ground2-3-4-5Height Sensor Power 6Height Sensor Signal 3. Circuit diagram ...

    Glove box lamp
    The glove box lamp comes on when the glove box is opened. CAUTION To prevent unnecessary charging system drain, close the glove box securely after using the glove box. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com