>
Hyundai Equus Manuals

Hyundai Equus: Oil Filter Repair procedures - Hydraulic System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Oil Filter Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Automatic Transmission System (SBC) / Hydraulic System / Oil Filter Repair procedures

Replacement
1.
Draining ATF totally.
2.
Remove the oil pan (A).

3.
Must be replaced by new oil pan.
   
Integrated filter in the oil pan is not replaceable.

4.
Adding automatic transmission fluid.
(Refer to "automatic transmission system" in this group.)
    Fluid Repair procedures
    Service Adjustment Procedure Oil level Check     A check of ATF level is not normally required during scheduled services. If an oil leak is found, perform the oil level chec ...

    Valve Body Description and Operation
    Description The valve body is essential to automatic transmission control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves consist of pr ...

    See also:

    Components and Components Location
    Component Location 1. Cluster assembly2. Battery sensor3. Washer fluid level sensor4. Fuel gauge sender ...

    Rear Hub - Carrier Repair procedures
    Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub .     Be care ...

    Rear Door Outside Handle Repair procedures
    Replacement 1. Remove the hole plug (B). 2. After loosening the mounting bolt, then remove the rear door outside handle cover (A). Tightening torque : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com