>

Hyundai Equus: Middle Speed Sensor Description and Operation - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Middle Speed Sensor Description and Operation

Description
The middle speed sensor measures the rate of rotation of the 6C outer drum inside the transmission and delivers the readings to the TCM.

    Input Speed Sensor Repair procedures
    Inspection 1. Check signal waveform of Input speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

    Middle Speed Sensor Specifications
    Specifications x Type: Hall effect sensor x Specifications Operation condition (°C)°F ((-)40~150)) -40~302Air gap(mm)in.1.3(0.0512)Output voltage(V)High1.4Low0.7 ...

    See also:

    Warning type
    The system will activate when: 1.The system is on 2.Vehicle speed is above 9.3 mph (15 km/h) 3.Other vehicles are detected in the rear side If a vehicle is detected within the boundary of the ...

    Air Quality Sensor (AQS) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Connect the GDS. 3. Check the output voltage of AQS between terminal 2 and 3. 1. DC 12V( Ignition)2. Sensor ground3. AQS signal Specif ...

    Components and Components Location
    Component Location 1. Start Stop Button(SSB)2. FOB key3. Trunk open switch4. RF receiver5. Interior antenna 16. Interior antenna 27. Interior antenna 38. Trunk antenna9. Door handle & do ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com