>

Hyundai Equus: Line Pressure Control Solenoid Vale Repair procedures - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Line Pressure Control Solenoid Vale Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
    Line Pressure Control Solenoid Vale Schematic Diagrams
    Circuit Diagram ...

    Damper Clutch Control Solenoid Valve Description and Operation
    Description Damper Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the Damper Clutch. ...

    See also:

    Limousine Front Body
    Front body A Roof panel front cornerFront pillar outer cornerHood hinge mounting hole (O13)Shockabsorber mounting hole (O24)Front end module mounting hole (O9)Cowl top cover mounting hole (O7) F ...

    Engine overheat
    If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1.Pull off the road ...

    Binding arbitration (U.S.A only)
    Any claim or dispute you may have related to your vehicle's warranty or the duties contemplated under the warranty, including claims related to the refund or partial refund of your vehicle' ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com