>
1.Open the trunk.
2.Disconnect the negative battery cable.
3.Using a screwdriver, remove the trunk lid latch cover(1).
4.Using a screwdriver, remove the trunk lid switch(2), and disconnect the connector.
5.Detach the clip and fastener(3), then remove the trunk lid cover(4).
6.Remove the clips and screws.
7.Remove the trunk lid trim.
CAUTION
Be careful not to damage to the fasteners between the trunk lid trim and trunk lid.
8.Remove the nuts and disconnect the connectors.
9. Remove the bolts and remove the trunk key hold.
10. Remove the trunk lid panel.
CAUTION
Be careful not to damage to the fasteners between the trunk lid panel and trunk lid.
11. Remove the bolts and remove the license plate lamp.
12. Install a new light.
13. Installation is the reverse of removal.
Lumbar Support Unit Components and Components Location
Components
Bladder & Massage ECU
...
Middle Speed Sensor Schematic Diagrams
Circuit Diagram
...
Spark Plug Specifications
Specification
ItemSpecificationTypeDILKR7A11Gap 1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.)
...