>
To operate the LDWS, pull the switch with the Engine Start/Stop Button in the ON position. The indicator illuminates on the cluster. To cancel the LDWS, pull the switch again.
LDWS indicator light illuminates:
If your vehicle leaves the lane when the LDWS is operating and vehicle speed exceeds 43 mph (70 km/h), the warning operates as follows:
1. Visual warning
If you leave the lane, the lane you leave on the LCD display blinks yellow.
2. Auditory warning
If you leave the lane, the warning sound operates.
3. Tactual warning (if equipped with pre-safe seat belt)
If you leave the lane for about 3 seconds, the pre-safe seat belt provides haptic warning.
You can activate or deactivate this feature. Refer to "User Settings Mode" in chapter 4.
The LDWS does not operate when:
✽ NOTICE
To change lanes, operate the turn signal switch then change the lane.
Steering Wheel Remote Controller (SWRC) Troubleshooting
Initialization and Troubleshooting Procedures
1.
Initialization Procedure
: Disconnect (connector or battery) for 30 seconds (time required for internal condenser discharge), then reconnect the p ...
Components and Components Location
Components Location
[Vehicle Components]
1. Transmission Control Module(TCM)2. Shift lever3. Date Link Connector (DLC)
[Transmission Components]
1. Input speed sensor2. Middle speed se ...
Economical operation
Your vehicle's fuel economy depends mainly on your style of driving, where you
drive and when you drive.
Each of these factors affects how many miles (kilometers) you can get from a
gallon (l ...