>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the LDWS unit cover (A). |
3. |
Remove the LDWS unit connector (A). |
4. |
Remove the front side of roof trim to remove the LDWS unit mounting bolts.
(Refer to Body group - "Roof Trim") |
5. |
Remove the LDWS unit after loosening the mounting bolts. |
Installation |
1. |
Install the LDWS unit. |
2. |
Install the roof trim. |
3. |
Install the LDWS unit cover. |
4. |
Check LDWS system operation. |
Blower Unit Components and Components Location
Component Location
Components
1. Intake Duct Case2. Intake Duct Case (A)3. Intake Door4. Intake Actuator5. Seal6. Blower Upper Case7. Blower Lower Case8. Seal9. Climate Control Air Filter Cover1 ...
Trailing Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element. Clean the filter
by using compressed air.
Main air cleaner
1. ...