>
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). |
3. |
Disconnect the knock sensor connector (A).
[Bank 1]
[Bank 2] |
4. |
Remove the cross over fuel pipe (A). |
5. |
Remove the installation bolt (A), and then remove the sensor from the cylinder block. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Memory Power Seat Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the door trim (A) after loosening mounting screws.
(Refer to Body - "Front Door Trim")
3.
Remove the memory power seat c ...
Tire Repair procedures
Tire Wear
1.
Measure the tread depth of the tires.
Tread depth [limit] : 1.6 mm (0.063 in)
2.
If the remaining tread (A) depth is less than the limit, replace the tire.
  ...
Trip A/B
✽ NOTICE
If you reset one of the tripmeter, elapsed time, and average vehicle speed,
they will be reset all together.
Tripmeter (1)
The tripmeter is the total driving distance since t ...