>
Removal |
1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the knee airbag (C) after loosening the srcrews (A) and nuts (B). |
Installation |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the battery negative cable and wait for at least three minutes. |
3. |
Tighten the knee airbag mounting screws (A) and nuts (B).
|
4. |
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
5. |
Reconnect the battery negative cable. |
6. |
After installing the knee airbag, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Alternator Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the engine cover.
3.
Remove the air cleaner assembly.
(1)
Remove the air duct (A).
(2)
D ...
Repair procedures
Air Injection Procedure
•
When injecting air into the air suspension system, always
raise the vehicle off the ground using a lift to prevent potential
damage to the ai ...
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Disconnect the accelerator control ...