>
Removal and Installation |
1. |
Disconnect the negative terminal (A) from the battery.
|
2. |
Remove the engine room cover (A), engine cover (B) and radiator grill upper cover (C). |
3. |
Remove the air cleaner assembly.
|
4. |
Remove the fuel hose (A), the purge control solenoid valve (PCSV) hose (B) and the brake booster vacuum hose (C). |
5. |
Disconnect the ETC module connector (A), PCSV connector (B) and the PCV hose (C). |
6. |
Disconnect the MAP sensor connect (A) located at the rear side of intake module. |
7. |
Remove the wiring harness protector bolts, mounted on the intake module and the cylinder head cover.
|
8. |
Remove the high pressure fuel pipe bracket bolt (A), low
pressure fuel tube bracket bolts (B) and the injector connector bracket
bolt (C).
|
9. |
Remove the intake manifold module (A).
|
10. |
Installation is reverse order of removal and tighten the manifold nuts with specified torque in the sequence shown. |
Blind Spot Detection Indicator Components and Components Location
Components
...
Components and Components Location
Components
1. ESP control module (HECU)2. Steering angle sensor3. Rear wheel speed sensor4. Sensor cluster (Yaw rate & Lateral)5. Front wheel speed sensor
...
Immobilizer system
The immobilizer system protects your vehicle from theft. If an improperly coded
key (or other device) is used, the engine’s fuel system is disabled.
When the Engine Start/Stop Button is in the ON p ...