>
Remove |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the IDB cover (A). |
3. |
Disconnect the IDB Connector (A). |
4. |
Remove the mounting bolts (B), and then remove the IDB (C). |
Installation |
1. |
Install in the reverse order of removal.
|
Rear Disc Brake Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Loosen the hose eye-bolt (B) and caliper mounting bolts (C), th ...
Instrument Cluster Schematic Diagrams
Circuit Diagram
...
General Information
General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
...