An in-car air temperature sensor is located in the heater control.
The sensor contains a thermistor which measures the
temperature of the cabin. The signal determined by the resistance value
which changes in accordance with perceived inside temperature, is
delivered to the heater control unit and according to this signal the
control unit regulates the in-car temperature to the intended value.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure the resistance between terminal “+” and “-” of the evaporator temperature ...
Inspection
1.
Turn the ignition switch ON.
2.
Blow warm air into the in-car sensor air inlet. Measure the sensor resistance between 1 and 3 terminals.
1. Sensor Ground 2. Motor (-)3. Incar ...
See also:
Changing the engine oil and filter
Have engine oil and filter changed by an authorized EQUUS dealer according to
the Maintenance Schedule at the beginning of this section.
CALIFORNIA PROPOSITION 65 WARNING
Engine oil contains c ...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it with the lever
in the OFF position. The wipers will operate conti ...
Sedan Under Body
Under body
Projected dimensions
Tooling hole (O25)Front sub frame mounting pipe (O25)Tooling hole (O14)Front sub frame mounting pipe (O27)Tooling hole (O15)Tooling & paint drain hole (O6.6 ...