>
The immobilizer system protects your vehicle from theft. If an improperly coded key (or other device) is used, the engine’s fuel system is disabled.
When the Engine Start/Stop Button is in the ON position, the Immobilizer System indicator should come on briefly, then go off. If the indicator starts to blink, the system does not recognize the coding of the Smart Key.
Press the Engine Start/Stop Button to the OFF position, then press the Engine Start/Stop Button to the ON position again.
The system may not recognize your Smart Key’s coding if another immobilizer key or other metal object (i.e., key chain) is near the Smart Key.The engine may not start because the metal may interrupt the transponder signal from transmitting normally.
If the system repeatedly does not recognize the coding of the Smart Key, contact your EQUUS dealer.
Do not attempt to alter this system or add other devices to it. Electrical problems could result that may make your vehicle inoperable.
✽ NOTICE
ALWAYS take the Smart Key with you when you leave the vehicle.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
✽ NOTICE
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.
LCD Display Control
The LCD display modes can be changed by using the control buttons on the steering
wheel.
1) button : Changing LCD modes
(right to left), or returning to previous position
(2) but ...
Driver Door Module (DDM) Description and Operation
Description
1.
Driver Door Module (DDM)
(1)
Main features
ItemExplanationNotesInstallation positon Driver side door trimComponent configuration
1.
Embedded with CAN Communication IC
2.
...
Water pump Repair procedures
Removal and Installation
Water Pump
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Remove the air du ...