>
Hyundai Equus Manuals

Hyundai Equus: Hood Assembly Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Hood Assembly Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Hood / Hood Assembly Repair procedures

Replacement
   
•
Be careful not to damage the hood and body.
   
•
When removing and installing the hood, an assistant is necessary.
•
When removing the clips, use a clip remover.
1.
Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B).

2.
After loosening the hood hinge (A) mounting bolts, remove the hood assembly (B).
Tightening torque :
21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)

3.
Installation is the reverse of removal.
   
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the hood alignment.
    Hood Assembly Components and Components Location
    Component Location 1. Hood assembly ...

    Hood Lift Repair procedures
    Replacement     • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver (A ...

    See also:

    Lower Arm Repair procedures
    Removal [Front Lower Arm] Replacement the lateral arm 1. Removal the front wheel & tire. Tightening torque : 90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft) 2. Disconnect ...

    Starter Relay Repair procedures
    Inspection 1. Disconnect the battery negative terminal. 2. Remove the fuse box cover. 3. Remove the starter relay(A). 4. Using an ohmmeter, check that there is continuity between each ...

    Components and Components Location
    Component Location 1. Hood switch2. Burglar horn3. BCM4. Key warning switch5. Front door switch6. Front door lock actuator & switch7. Rear door lock actuator & switch8. Rear door switch9. ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com