>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the height sensor linkage (A) installed on the front axle and rear axle.
(Number of height sensor : Air suspension - 4EA, Non-air suspension - 2EA)
[Front]
[Rear] |
3. |
Remove the height sensor assembly after disconnecting the connector.
[Front]
[Rear] |
4. |
Remove the height sensor unit (A) after removing screws(2EA).
[Front]
[Rear] |
Installation |
1. |
Install the height sensor unit. |
2. |
Install the height sensor assembly after connecting the connector. |
3. |
Install the height sensor linkage on the front axle and rear axle. |
4. |
Connect the negative (-) battery terminal. |
Inhibitor Switch Specifications
Specifications
x Type: Combination of output signals from 4 terminals
Power supply (V)12Output typeCombination of output signals
Signal Code Table
PIN No.PP-RRR-NNN-DDS112V12VO ...
Air bag
(1) Driver’s front air bag
(2) Passenger’s front air bag
(3) Side impact air bag
(4) Curtain air bag
(5) Driver’s knee air bag
WARNING
Even in vehicles with air bags, you and your passengers m ...
General Information
General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
...