>

Hyundai Equus: Heater Control Unit Repair procedures - Controller - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Heater Control Unit Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim")
3.
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down.

4.
Disconnect the under lamp connector (A).

5.
Remove the stopper (B) from the glove box (A).

6.
Disconnect the air damper (A) from the glove box (B).

7.
Remove the glove box housing (A) after loosening the mounting screws and nuts.

8.
Disconnect the glove box lamp connector (A).

9.
Remove the passenger's side shower duct (A).

10.
Unscrew the mounting srcrews and then remove the control unit (A).

11.
Install in the reverse order of removal.
    Heater Control Unit Components and Components Location
    Control Panel Component Connector Pin Function Pin No.Connector AConnector B1GroundIgnition 22-FET (Gate)3Mode Control Actuator (Vent)FET (Drain Feedback)4Mode Control Actuator (Defrost)Sen ...

    See also:

    Repair procedures
    Adjustment Glass Adjustment     • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove the rear door trim. (Refer to Rear ...

    Trunk Lid Trim Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

    Schematic Diagrams
    Circuit Diagram NO.Function1BAT.2IGN3CAN_High4CAN_Low5GND6- ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com