>
Control Panel |
Component |
Connector Pin Function |
Pin No. | Connector A | Connector B |
1 | Ground | Ignition 2 |
2 | - | FET (Gate) |
3 | Mode Control Actuator (Vent) | FET (Drain Feedback) |
4 | Mode Control Actuator (Defrost) | Sensor REF (+5V) |
5 | Intake Actuator (Fresh Air) | - |
6 | Intake Actuator (Recerculated Air) | - |
7 | Driver's Temperature Control Actuator (Cool) | Incar Sensor Motor (-) |
8 | Driver's Temperature Control Actuator (Warm) | - |
9 | Passenger Temperature Control Actuator (Cool) | - |
10 | Passenger Temperature Control Actuator (Warm) | ECV (+) |
11 | Auto Defogging Actuator (Open) | ECV (-) |
12 | Auto Defogging Actuator (Close) | - |
13 | Console Temperature Control Actuator (Cool) | Rear Auto Indcicator |
14 | Console Temperature Control Actuator (Warm) | ION Signal |
15 | Console Temperature Control Actuator A (Cool) | Blower Motor (+) |
16 | Console Temperature Control Actuator A (Warm) | CLEAN Signal |
17 | Console Duct Actuator (Vent) | - |
18 | Console Duct Actuator (Floor) | - |
19 | - | C-Line (Rear Armrest) |
20 | Sensor Ground | - |
21 | - | C_CAN (High) |
22 | Mode Control Actuator Feedback | C_CAN (Low) |
23 | Intake Actuator Feedback | - |
24 | Driver's Temperature Control Actuator Feedback | Climate_CAN High |
25 | Passenger's Temperature Control Actuator Feedback | Climate_CAN Low |
26 | Auto Defogging Actuator Feedback | - |
27 | Console Temperature Control Actuator Feedback | - |
28 | Console Temperature Control Actuator A Feedback | C-Line (Console LCD Panel) |
29 | Console Duct Actuator Feedback | - |
30 | Cluster Ion generator Diagnosis | Ignition 1 |
31 | AQS Signal | Battery |
32 | - | Ignition 2 |
33 | - | x x x x x x x x |
34 | Humidity (PWM) | |
35 | Incar Sensor | |
36 | Ambient Temperature Sensor | |
37 | Evaporator Temperature Sensor | |
38 | - | |
39 | Console Duct Sensor (+) | |
40 | - |
Rear Wheel House Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protec ...
Fuel Filter Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressu ...
Smart Key Unit Components and Components Location
Components
Connector Pin Information
No.Connector AConnector BConnector C1V_BAT loadC_CAN LowSSB illumination ground2-C_CAN High-3Power ground1-SSB LED OFF4IGN1-Interior antenna #2 power5IGN1 rela ...