Hyundai Equus: Heated Oxygen Sensor (HO2S) Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Engine Control/Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Description and Operation
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Engine Control/Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Description and Operation
| Description |
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina
and is installed both upstream and downstream of the Manifold Catalytic
Converter. The sensor output voltage varies in accordance with the
air/fuel ratio.
The sensor must be hot in order to operate normally. To keep
it hot, the sensor has a heater which is controlled by the ECM via a
duty cycle signal. When the exhaust gas temperature is lower than the
specified value, the heater warms the sensor tip.
Knock Sensor (KS) Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the ...
Heated Oxygen Sensor (HO2S) Specifications
Specification
A/F Ratio (x)Output Voltage(V)RICH0.6 ~ 1.0LEAN0 ~ 0.4
ItemSpecificationHeater Resistance (x)Approx. 9.0 [21°C(69.8°F)]
...
See also:
Hood Insulator Pad Repair procedures
Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
•
Be careful not to scratch the hood panel.
2.
Installation is the ...
Blind Spot Detection Indicator Components and Components Location
Components
...
Damper Clutch Control Solenoid Valve Specifications
Specifications
Damper Clutch Control VFS
x Control type : Normal low type
Control Pressure kpa (kgf/cmx, psi)0~500.14 (0~5.1,0~72.54)Current value(mA)0~850 Internal resistance( ...
Categories
Hyundai Equus Manuals
© 2011-2024 Copyright www.heqmanual.com