>
Inspection |
1. |
Check "IPM" input/output specification of hazard lamp switch
using the GDS. If the specification is abnormal, replace the hazard
switch module. |
2. |
Select option "Input/output monitoring". |
Blind Spot Detection Unit Repair procedures
Removal
Blind spot detection (BSD) unit
1.
Disconnect the negative (-) battery.
Be careful when removing the blind spot detection unit. The bracket may break off from the b ...
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of ATF level is not normally required during
scheduled services. If an oil leak is found, perform the oil level chec ...
Rear Curtain Repair procedures
Inspection
Connect the battery voltage and check the rear curtain motor
rotation. If the motor does not operate properly, substitute with a
known-good rear curtain motor and check for proper op ...