>
Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Measure the output voltage of the FTPS.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the fuel pump service cover (A). |
3. |
Disconnect the fuel tank pressure sensor connector (A). |
4. |
Remove the fuel tank pressure sensor after remove the installation botl (B). |
Installation |
|
|
1. |
Install in the reverse order of removal. |
Rear Package Tray Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protec ...
Rear Door Side Curtain Components and Components Location
Components
1. Extention profile2. Bearing3. Integrated Helix drive4. Cassette5. Bearing6. Flap7. Antenna8. Driving unit
...
Blower Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
3.
Separate the blower unit (A) from the heater un ...