>
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pressure in Fuel Line"")" |
3. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
4. |
Disconnect the fuel pump & sender ground (A). |
5. |
Disconnect the fuel pump connector & fuel sender connector (A). |
6. |
Lift the fixing hook (B) by using a common driver, and then remove the fuel sender (C). |
Installation |
1. |
Install in the reverse order of removal. |
Description and Operation
Description
The starting system includes the battery, starter, solenoid
switch, ignition switch, inhibitor switch (A/T), clutch pedal switch
(M/T), ignition lock switch, connection wires and th ...
Schematic Diagrams
Circuit Diagram
Multi-view Camera System Input/Output
1.
Camera input
ItemSpecificationLens angle of view190 degreesAngle of viewHorizontal186 degreesVertical135 degreesFunctionProvides ...
Electronic Active Headrest Repair procedures
Inspection
1.
How to reassemble the Headrest which was released by rear (or front) Impact.
2.
How to unlock the trigger in case of trigger is locked.
(1)
Normally, the trigger position is un ...