>
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pressure in Fuel Line"")" |
3. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
4. |
Remove the sub fuel sender.
(Refer to Fuel Delivery System - "Sub Fuel Sender") |
5. |
Disconnect the suction hose (A). |
6. |
Remove the head assembly (C ) after removing the fixing hook (B). |
7. |
Disconnect the dual hose (A). |
8. |
Release the fixing hook, and then remove the free filter (A) and fuel pump motor (B). |
Installation |
1. |
Install in the reverse order of removal. |
Head Up Display Information
1. Cruise setting speed
2. Lane Departure Warning System (LDWS) information (if equipped)
3. Advanced Smart Cruise Control (ASCC) information (if equipped)
4. Road signs
5. Speedometer
6. Tur ...
Transmission Oil Temperature Sensor Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Checking the brake fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake fluid, ...