>
Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Check the output voltage of fuel pressure sensor (FPS).
|
Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-)battery cable. |
2. |
Folding the rear seat cushion. |
3. |
Remove the fuel pump service cover (A) after loosening the screws. |
4. |
Disconnect the fuel pressure sensor connector (A). |
5. |
Remove the fuel pressure sensor fixing pin (B) in the direction of the arrow . |
6. |
Remove the fuel pressure sensor (C) from the fuel pump. |
Installation |
1. |
Install in the reverse order of removal. |
Around view monitoring system (AVM) (If equipped)
This is the parking support system to show around circumstance when you park
the vehicle in monitor. When you push the button in [ON] position, it is operated.
To cancel the system, pu ...
Repair procedures
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the front looking sensor to stop functioning.
...
Rear Seat Belt Retractor Repair procedures
Replacement
•
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear package tray trim.
(Refer to Interior Trim - "Rear Package Tray T ...