>
Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-)battery cable. |
2. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") |
3. |
Disconnect the fuel pressure control valve connector (A) and the fuel feed tube quick-connector (B). |
4. |
Disconnect the vapor hose (A) which is connected from the PCSV. |
5. |
Remove the fuel tank.
(Refer to Fuel Delivery System - “Fuel Tank”) |
6. |
Remove the mounting nuts (A) and then, remove the fuel & brake line protector (B). |
7. |
Remove the mounting nuts (A). |
8. |
Remove the vapor tube line fixing clip (B) by using a common driver. |
9. |
Remove the mounting bolt. |
10. |
Remove the vapor tube and fuel tube line fixing clip (A) by using a common driver. |
11. |
Remove the fuel line (A). |
Installation |
1. |
Install in the reverse order of removal.
|
Inspection |
1. |
Start the engine. |
2. |
Check the fuel feed line (A) installation state and fuel leakage state. |
3. |
Folding the rear seat cushion. |
4. |
Remove the fuel pump service cover (A) after loosening the screws. |
5. |
Check the fuel feed quick-connector (A) installation state and fuel leakage state. |
6. |
Lift the vehicle. |
7. |
Check the fuel leakage state. |
8. |
Replace the fuel line after checking the abnormal fuel line.
(Refer to Fuel Delivery System - "Fuel Line") |
Power outlet
The power outlet is designed to provide power for mobile telephones or other
devices designed to operate with vehicle electrical systems. The devices should
draw less than 10 amps with the engin ...
Vehicle identification number (VIN)
The vehicle identification number (VIN) is the number used in registering your
car and in all legal matters pertaining to its ownership, etc.
The number is punched on the floor under the front ...
Roof Side Molding Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...