>
Removal |
1. |
Remove the connector after removing the front wheel speed sensor clip. |
2. |
Remove the front wheel speed sensor.
(Refer to Driveshaft and Axle - "Front Axle Assembly") |
3. |
Installation is the reverse of removal. |
Inspection |
1. |
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
|
2. |
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.
|
Crankshaft Position Sensor (CKPS) Specifications
Specification
ItemSpecificationCoil Resistance (x)774 ~ 946 [20°C (68°F)]Air cap(mm)0.5 ~ 1.5
...
Starter Components and Components Location
Components
1. Front bracket2. Planet gear shaft assembly3. Lever4. Lever packing5. Magnet switch6. Through bolt7. Planet gear 8. Shield9. Armature assembly10. York assembly11. Brush holder assemb ...
Hood Assembly Components and Components Location
Component Location
1. Hood assembly
...