>

Hyundai Equus: Front Wheel Guard Repair procedures - Body Side Molding - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Front Wheel Guard Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the front tire.
2.
After loosening the mounting clips and screws, then remove the front wheel guard (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
    Roof Side Molding Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

    Rear Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply prote ...

    See also:

    Driving in flooded areas
    Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perfo ...

    Hood Lift Repair procedures
    Replacement     • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver (A ...

    Room Lamp Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver. 3. Remove the room lamp (A) after removin ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com