>
Removal |
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper") |
3. |
Remove the front head lamp assembly.
(Refer to Lighting System / Head Lamp) |
4. |
Remove the washer hose and the washer motor connector (A) and the washer fluid level sensor connector (B). |
5. |
Remove the washer reservoir 2 bolts. |
6. |
Remove the mounting bolts of air suspension reserive tank
under the washer reserive in order to make easier to remove washer tank.
But, do not disconnect air hose.
(Refer to Suspension - "Front Suspension System") |
7. |
Remove the washer reserior after loosening the mounting bolt from the lower and of washer reserivor |
Inspection |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 2 and negative (-) battery cables to terminal 1 respectively. |
3. |
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. |
4. |
If they are abnormal, replace the washer motor.
(Connector NO.1 : Windshield washer (+), 2: Ground) |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Drain the washer fluid less than 650 cc. |
3. |
Check for continuity between the No. 1 and No.2 terminal in each float position.
There should be continuity when the float is down.
There should be no continuity when the folat is up. |
4. |
If the continuity is not as specified, replace the washer fluid level switch |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 2 and negative (-) battery cables to terminal 1 respectively. |
3. |
Check that the motor operates normally and the washer motor runs and water sprays from the head lamp nozzles. |
4. |
If they are abnormal, replace the washer motor. |
Installation |
1. |
Install the washer reservoir.
|
2. |
Install the washer motor hose and connectors. |
3. |
Install the air suspension reserve tank bolts. |
4. |
Install the head lamp assembly. |
5. |
Install the front bumper cover. |
Canister Close Valve (CCV) Description and Operation
Description
Canister Close Valve (CCV) is normally open and is installed
on the canister ventilation line. It seals evaporative emission control
system by shutting the canister from the atmosph ...
Rear Left Door Module (RLDM) Description and Operation
Description
1.
Rear Left Power Window Switch
(1)
Main features
ItemExplanationInstallation location Rear Left Door TrimComponent configuration
1.
Embedded with LIN Communication IC
2.
...
Emergency braking
If there is a problem with the foot brake while driving, emergency braking is
possible by pulling and holding the EPB switch.
However, braking distance will be longer than normal condition.
WARNIN ...