>
Replacement |
|
1. |
Remove the safety belt (A) by turning it in the direction of arrow using a flat-head screwdriver. |
2. |
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim") |
3. |
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim") |
4. |
After loosening the mounting bolt, then remove the front seat belt lower anchor (A).
|
5. |
Loosen the front seat belt webbing guide (A) mounting bolts. |
6. |
After disconnecting the pretensioner connector lock pin,
remove the front seat belt pretensioner connectors (A), loosen the
mounting bolts, then remove the front seat belt pretensioner (B).
|
7. |
Install in the reverse order of removal.
|
Mode Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...
General Information
Identification Number Locations
Identification Number Description
Vehicle Identification Number
1.
World Manufacturer Identifier (WMI)
- KMF : Commercial vehicle (Van)
- KMH : Passenger vehicl ...
Front Area Module(FAM) Components and Components Location
Components
...