>
Replacement |
|
|
1. |
Pull up the front seat headrest by pressing the power seat control switch. |
2. |
Pull up the front seat headrest (A). |
3. |
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly") |
4. |
Remove the front seat rear shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover") |
5. |
Disconnect the front seat under lamp connector (A). |
6. |
Using a screwdriver or remover, remove the rear monitor bezel (A). |
7. |
Press the clip (B) on top to remove the front seat back board (A).
|
8. |
Disconnect the air ventilation seat duct connector (A). |
9. |
After loosening the mounting screws, then remove the air ventilation seat duct (B). |
10. |
Remove the rear bumper joint connector mounting bolts (A). |
11. |
After loosening the mounting bolt, then remove the monitor (B). |
12. |
Pull out the protecter (A) by the front seat back frame. |
13. |
Pull up the front seat headrest guides (A). |
14. |
Remove the front seat back cover (A) from the front seat back frame. |
15. |
After removing the hog-ring clips on the front of seat back and remove the front seat back cover (A). |
16. |
Install in the reverse order of removal.
|
Rear Bumper Beam Assembly Components and Components Location
Component Location
1. Rear bumper beam assembly
...
3 Zone control button
1. Press the 3 zone button to operate the front passenger's temperature, rear
side temperature, and rear side mode individually. The indicator on the 3 zone button
will be illuminated. Press ...
Trunk Lid Control Button
When the trunk lid control button is ON (depressed), the power trunk can be controlled
with the power trunk main control button, power trunk open, close button, and the
smart key.
When this t ...