>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the crash pad lower panel and then push the rear parking assist switch (A) to remove it.
|
Installation |
1. |
Install the rear parking assist switch after connecting the connector. |
2. |
Install the crash pad lower panel. |
Inspection |
1. |
Check that continuity exists between the terminals. If there is no continuity, replace the seat heater switch. |
Steering Wheel Remote Controller (SWRC) Troubleshooting
Initialization and Troubleshooting Procedures
1.
Initialization Procedure
: Disconnect (connector or battery) for 30 seconds (time required for internal condenser discharge), then reconnect the p ...
Front Seat Belt Buckle Components and Components Location
Component Location
1. Front seat belt buckle
...
Assist Power Seat Module(APSM) Description and Operation
Description
1.
Assist Power Seat Module (APSM)
(1)
Main features
ItemDescriptionInstallation location Lower section of the assist side seatComponent configuration
1.
Embedded with CAN Commu ...