>
Replacement |
[Front Console Assembly] |
|
|
1. |
Using a screwdriver or remover, remove the gear boots (B). |
2. |
To remove the gear knob (A) and gear boots (B) pull both of it up. |
3. |
Using a screwdriver or remover, remove the front console upper cover (A). |
4. |
Disconnect the connectors (A). |
5. |
Using a screwdriver or remover, remove the console side cover (A).
[LH]
[RH] |
6. |
Disconnect the floor console main connector (A). |
7. |
Remove the console armrest tray (A). |
8. |
Remove the console armrest service cover (A). |
9. |
After loosening the mounting screws and bolts, then remove the floor console assembly (A). |
10. |
Install in the reverse order of removal.
|
[Rear Console Assembly] |
1. |
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
2. |
Disconnect the connectors (A). |
3. |
Remove the caps (B). |
4. |
After loosening the mounting bolts, remove the rear tower console complete assembly (C). |
5. |
Remove the nozzle assembly (A). |
6. |
Disconnect the connectors (A). |
7. |
After loosening the mounting bolts, remove the rear floor console complete assembly (A). |
8. |
Install in the reverse order of removal.
|
Injector Drive Box (IDB) Schematic Diagrams
Injector Drive Box (IDB)
IDB Connector
ECM Terminal Function
Connector [C200-IDB]
Pin No.DescriptionConnected to1ECM groundChassis ground2ECM groundChassis ground3Battery power (B+)Main rela ...
Troubleshooting
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptomProbable causeRemedyThe set vehicle speed varies greatly upward or downward"Surging" (repeated alternating accelera ...
Components and Components Location
Components
1. Receiver
...