>
Removal |
1. |
Disconnect the fuel filler hose (A) and the leveling hose (B). |
2. |
Disconnect the vapor hose quick-connector (A) after removing the trunk luggage trim. |
3. |
Remove the rear-LH wheel, tire, and the inner wheel house. |
4. |
Remove the filler-neck assembly from the vehicle after
removing the vapor hose mounting bolts (A) and the bracket mounting nuts
(B). |
Installation |
1. |
Install in the reverse order of removal.
|
ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle ...
Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots
of trees. Become familiar with the off-road conditions where you are going to drive
before you begin driving. ...
Rear Package Tray Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protec ...