>
Removal and Installation |
1. |
Disconnect the negative terminal (A) from the battery.
|
2. |
Remove the engine room cover (A), engine cover (B) and radiator grill upper cover (C). |
3. |
Remove the air cleaner assembly.
|
4. |
Remove the oil level gauge (A).
|
5. |
Disconnect the LH/RH oxygen sensor (HO2S) connectors (A) and remove the connector from the bracket. |
6. |
Remove the exhaust manifold stay (A) and then disconnect the front muffler (B) on LH and RH side.
|
7. |
Remove the LH/RH exhaust manifold heat protectors (A).
[RH]
[LH]
|
8. |
Remove the LH/RH exhaust manifolds (A).
[RH]
[LH]
|
9. |
Remove the LH/RH exhaust manifold gaskets.
|
10. |
Installation is reverse order of removal.
[LH]
[RH]
|
27 Brake Control Solenoid Valve Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negative ...
Specifications
Specifications
ItemSpecificationMaster cylinderTypeTandemCylinder I.D.25.4mm (1.00in)Piston stroke35±1mm (1.38in)Fluid level switchProvidedBrake boosterType8" + 9" TandemBoosting ratio9 : 1Front ...