>
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit") |
3. |
Remove the heater unit lower case (A) after loosening the mounting screws. |
4. |
Pull out the evaporator core (A) from the heater unit.
|
5. |
Install in the reverse order of removal.
|
8LR Brake Control Solenoid Valve Specifications
Specifications
Direct control VFS[8LR/B]
x Control Type : Normal low type
Control Pressure kpa (kgf/cmx, psi)0 ~ 2108.42(0 ~ 21.5, 0 ~ 305.80)Current value(mA)0~1100 Internal r ...
Rear Seat Frame Assembly Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply pro ...
Power Trunk Module Drive Unit Components and Components Location
Component Location
1. Gear motor2. Drive bracket3. Push rod4. Gear5. Drive arm6. Power trunk module control unit7. Push rod pin
...