>
Fail-safe mode |
ITEMS | FAIL-SAFE | |
ETC Motor | Throttle valve stuck at 5° | |
TPS | TPS 1 fault | Replace it with TPS2 |
TPS 2 fault | Replace it with TPS1 | |
TPS 1,2 fault | Throttle valve stuck at 5° | |
APS | APS 1 fault | Replace it with APS2 |
APS 2 fault | Replace it with APS1 | |
APS 1,2 fault | Throttle valve stuck at 5° |
When throttle value is stuck at 5°, engine speed is limited
at below 1,500rpm and vehicle speed at maximum 40 ~ 50 km/h (25 ~
31mph). |
Photo Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will ri ...
Rear Glass Defogger Printed Heater Repair procedures
Inspection
Wrap tin foil around the end of the voltmeter test lead to
prevent damaging the heater line. Apply finger pressure on the tin foil,
moving the tin foil along th ...
Hazard Lamp Switch Repair procedures
Inspection
1.
Check "IPM" input/output specification of hazard lamp switch
using the GDS. If the specification is abnormal, replace the hazard
switch module.
2.
Select option "Input/output ...