Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle angle(°)
| Output Voltage (V)
| TPS1
| TPS2
| C.T
| 0.5
| 4.5
| W.O.T
| 4.41
| 0.59
|
|
ETC Motor
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the ETC module connector. |
| 3. |
Measure resistance between the ETC module terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
Specification: Refer to “Specification”
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Remove the resonator and the air intake hose (Refer to “Intake And Exhaust System” in EM group). |
| 3. |
Disconnect the ETC module connector (A). |
| 4. |
Remove the installation bolts (B), and then remove the ETC module (C) from the engine. 
|
| • |
Install the component with the specified torques. |
| • |
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing. |
|
| 1. |
Install in the reverse order of removal.
Electronic throttle body Installation bolt:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
| ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
| 1. |
Hold the ignition key or the start button at th IG ON position during 5 seconds. |
| 2. |
Turn ignition swich OFF and then start the engine. |
|
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module. |
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute
pressure of the surge tank and transfers the analog si ...
See also:
Adaptive Front Lighting System Repair procedures
Removal
AFLS Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing (A). (Refer to the Body group - "Crash pad")
3.
Disconnect the glove box housing connect ...
Schematic Diagrams
ESP Circuit Diagram
ESP Connector Input/Output
[Standard]
[Premium]
Connector TerminalSpecificationPin NoDescriptionStandardPremium2931IGNITION1(+)High level of wake up voltage : 4.5V < ...
Keep your garage dry
Don't park your car in a damp, poorly ventilated garage. This creates a favorable
environment for corrosion.
This is particularly true if you wash your car in the garage or drive it into
the ...
Hyundai Equus: ETC (Electronic Throttle Control) System Repair procedures
Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Engine Control/Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Repair procedures
ETC (Electronic Throttle Control) System Schematic Diagrams
Manifold Absolute Pressure Sensor (MAPS) Description and Operation