>
Inspection |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable |
2. |
Remove the crash pad side cover. |
3. |
Remove the lower panel.
(Refer to Body - "Crash Pad") |
4. |
Remove the lower crash pad switch assembly by using the scraper and then disconnect the connectors. |
5. |
Check the continuity between the switch terminals as the ESP OFF switch is engaged. |
Intake Actuator Description and Operation
Description
The intake actuator is located at the blower unit. It
regulates the intake door by a signal from the control unit. Pressing
the intake selection switch will shift between recirculat ...
Snow tires
If you equip your car with snow tires, they should be the same size and have
the same load capacity as the original tires. Snow tires should be installed on
all four wheels; otherwise, poor handli ...
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wi ...