>
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
2. Release both buttons. Do not hold for longer than 20 seconds.
The Integrated HomeLink® Wireless Control System is now in the training (learn) mode and can be programmed at any time following the appropriate steps in the Programming sections above.
FCC ID: NZLTLMHL4 IC: 4112A-TLMHL4
Smart Key Unit Schematic Diagrams
Circuit Diagram
...
Front LCD monitor Components and Components Location
Components
...
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of ATF level is not normally required during
scheduled services. If an oil leak is found, perform the oil level chec ...