>
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash-after 20 seconds.
2. Release both buttons. Do not hold for longer than 30 seconds.
The Integrated HomeLink® Wireless Control System is now in the training (learn) mode and can be programmed at any time following the appropriate steps in the Programming sections above.
FCC ID: NZLZTVHL3 IC: 4112A-ZTVHL3
Emission control system
The emission control system of your vehicle is covered by a written limited warranty.
Please see the warranty information contained in the Owner’s Handbook & Warranty
Information booklet in yo ...
Components and Components Location
Components
1. Front seat headrest2. Front seat headrest guide3. Front seat back cover4. Front seat cushion cover5. Front seat cushion pad6. Front seat back cushion frame7. Front seat mounting cov ...
Brake Switch Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the lower crash pad.
(Refer to the Body - "Crash Pad")
3.
Disconnect the stop lamp switch con ...