>
Adjustment |
|
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Carefully move the glass (A) until the glass mounting bolt are visible, then loosen them. |
3. |
Check that the glass moves smoothly. |
|
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment. |
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches
properly, tighten the screws and recheck. |
|
1. |
Check that the door and body edges are parallel. |
2. |
Place the vehicle on a firm, level surface when adjusting the doors. |
3. |
Adjust at the hinges (A) :
|
4. |
Grease the pivot portions of the hinges indicated. |
5. |
Check for water leaks. |
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of ATF level is not normally required during
scheduled services. If an oil leak is found, perform the oil level chec ...
Blind Spot Detection Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery.
2.
Remove the crash pad lower panel (A).
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the crash pad lower panel and then push the bl ...
Specifications
Specifications
ItemSpecificationMaster cylinderTypeTandemCylinder I.D.25.4mm (1.00in)Piston stroke35±1mm (1.38in)Fluid level switchProvidedBrake boosterType8" + 9" TandemBoosting ratio9 : 1Front ...