>

Hyundai Equus: Trunk Lid Assembly Repair procedures

Second generation VI (2009–2024) / Hyundai Equus VI 2009-2024 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Assembly Repair procedures

Replacement

•	Wear gloves to protect hands from injury.

•	When removing and installing the trunk lid, an assistant is necessary.

1.	Remove the trunk lid trim. (Refer to Trunk Lid - "Trunk Lid Trim")

2.	Disconnect the connectors and trunk lid wiring harness (A).

3.

After loosening the mounting bolts, then remove the trunk lid assembly (B).

Tightening torque :

21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)

4.

Install in the reverse order of removal.

•	Make sure the trunk lid locks/unlocks and opens/closes properly.

•	Adjust the trunk lid alignment.

•	Make sure the connectors are connected in properly.

•	Replace any damaged clips.

Trunk Lid Assembly Components and Components Location

Component Location 1. Trunk lid assembly ...

Trunk Lid Trim Components and Components Location

Component Location 1. Trunk lid trim ...

See also:

Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative impact on the air conditioning system. Therefore, if abnormal operation is ...

Brake Line Repair procedures
Removal 1. Remove the wheel & tire. 2. Remove the brake hose clip (A). Front Rear 3. Disconnect the brake tube by loosening the tube flare nut. Tightening torque : 12.7 ~ 16.7 N ...

Limousine Interior
Interior A Front inner pillar tooling hole (O9)Cowl cross bar mounting hole (O11)Front door checker mounting hole (O11)Side sill inner reinforcement tooling hole (O7)Seat belt height adjuster upp ...

Categories

Hyundai Equus Manuals

© 2011-2024 Copyright www.heqmanual.com