>
Replacement |
1. |
Remove the hood latch cover (A) mounting clip.
(Refer to Engine Mechanical System - "Active Air Flap(AAF)") |
2. |
Loosen the hood latch (B) mounting bolts.
|
3. |
Disconnect the connector (A), then remove the wiring mounting clips. |
4. |
Installation is the reverse of removal.
|
Rear Console Cover Components and Components Location
Component Location
1. Rear console cover
...
Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Tur ...
Cylinder Block Repair procedures
Disassembly
Engine removal is required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors ca ...