>

Hyundai Equus: Hood Lift Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Hood Lift Repair procedures

Replacement
   
When removing and installing the hood lifter, an assistant is necessary.
When removing the clips, use a clip remover.
1.
Using a screwdriver (A), lift the socket clips (B) up slightly on both ends of the lifter and then remove the lifter from the bracket.

2.
Push the socket of the lifter into the bracket for installation.
   
Make sure the hood locks/unlocks and opens/closes properly.
    Hood Assembly Repair procedures
    Replacement     • Be careful not to damage the hood and body.     • When removing and installing the hood, an assistant is necessary. • When rem ...

    Hood Insulator Pad Repair procedures
    Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A).     • Be careful not to scratch the hood panel. 2. Installation is the ...

    See also:

    Rear Stabilizer Bar Repair procedures
    Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • Be careful not to damage t ...

    Smart Cruise Control Unit Description and Operation
    Description The smart cruise control unit is installed on the front center of the chassis. A radar sensor is embedded in the front section of the unit. This sensor detects vehicles and objects ...

    Fuel Filter Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressu ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com